LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 757 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the shock absorber to the vehicle.
    2. NOTE: Refer to Fastener Notice .
    Fig 1: View Of Shock Absorber
    GM855039Courtesy of GENERAL MOTORS CORP.
  2. Install NEW upper and lower shock bolts.

    Tighten: 

    • Tighten the upper bolt to 90 N.m (66 lb ft).
    • Tighten the lower bolt to 110 N.m (81 lb ft).

  3. Remove the jack stand.
  4. Install the wheel. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals