Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to BATTERY DISCONNECT CAUTION .

Disconnect the negative battery cable from the battery negative terminal.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the electrical connector at the vehicle speed sensor.

Fig 1: Vehicle Speed Sensor (VSS) & Retaining Stud

Courtesy of GENERAL MOTORS CORP.

Remove the retaining stud and the sensor. Pull straight out in order to avoid damage to the case.