LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Intermediate/Fourth Servo Assembly Replacement >> Assemble Procedure

Assemble Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intermediate/Fourth Servo Components
    GM1778405Courtesy of GENERAL MOTORS CORP.
  1. Install the servo cushion springs (68) and the servo piston (77) onto the servo pin (76).
  2. Install the snap ring (70) onto the servo pin (76) in order to retain the springs (68) and piston (77).
  3. Install the new seals (78 and 79) onto the servo piston (77) and the servo cover (80).
  4. Install the servo piston assembly into the servo cover (80). Lubricate the piston seals with transmission fluid in order to aid in assembly.
scientia non olet · About LEMON Manuals