LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Wiring Harness Connection

Wiring Harness Connection

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wiring Harness Pass Thru Connector
    GM20312Courtesy of GENERAL MOTORS CORP.
  1. Inspect the wiring harness (11) for damage.
  2. Inspect the pass thru connector pins and o-ring seal for damage.
  3. Assemble the wiring harness pass thru connector into the transaxle case bore from the inside of the transaxle case.
scientia non olet · About LEMON Manuals