Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Turbine Shaft O-Ring

Courtesy of GENERAL MOTORS CORP.

Install a new turbine shaft O-ring (41) on the end of the turbine shaft.

CAUTION: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly.

Install the torque converter onto the transmission.
Install the J 21366 . See Special Tools .
Remove the transmission from the holding fixture.