LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Reaction Internal Gear, Input Carrier Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Input Carrier Assembly To Reaction Internal Gear
    GM20254Courtesy of GENERAL MOTORS CORP.
  1. Assemble the input carrier assembly (562) to the reaction internal gear (560.
  2. Retain the input carrier assembly with the snap ring (563).
  3. Assemble the thrust bearing (107) onto the input carrier assembly.
  4. Retain the thrust bearing with J 36850  or equivalent. See Special Tools . You will find another thrust bearing permanently retained in the input carrier assembly (562).
scientia non olet · About LEMON Manuals