Output Speed Sensor Installation

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Vehicle Speed Sensor Components

Courtesy of GENERAL MOTORS CORP.

Inspect the vehicle speed sensor (62) for damage to the sensor, the electrical connector, or the O-ring (63).
Clean and dry the vehicle speed sensor (62).

Fig 2: Locating Output Shaft Speed Sensor

Courtesy of GENERAL MOTORS CORP.

Install the O-ring (63) onto the speed sensor (62).
Install the speed sensor (62) into the transmission case.

NOTE: Refer to FASTENER NOTICE .

Install the speed sensor stud (61).
Tighten: Tighten the speed sensor stud to 12 N.m (9 lb ft).