LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Final Drive and Differential Assembly Install >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Sun Gear Grooved Side Up
    GM20234Courtesy of GENERAL MOTORS CORP.
  1. Install the final drive carrier to case thrust bearing (117) onto the final drive carrier. Retain the bearing with J 36850  . See Special Tools .
  2. Install the complete final drive carrier assembly (116) into the transmission case (51).
  3. Install the thrust bearing (700) into the final drive carrier assembly (116). Retain the bearing with J 36850  . See Special Tools .
    4. IMPORTANT: Install the sun gear with the grooved side up (flat side down).
  4. Install the final drive sun gear (115) into the final drive carrier (116).
scientia non olet · About LEMON Manuals