LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Drive Sprocket, Driven Sprocket, and Drive Link Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Drive Sprocket, Driven Sprocket & Drive Link
    GM1644722Courtesy of GENERAL MOTORS CORP.
  1. Install the drive sprocket to drive sprocket support thrust washer (38) to the drive sprocket (37). Place the tabs on the thrust washer into the holes on the drive sprocket.
  2. Retain the thrust washer with J 36850  or equivalent. See Special Tools .
  3. Install the driven sprocket to driven sprocket support thrust washer (92) onto the driven sprocket support (95).
    4. IMPORTANT: Orient the drive link assembly (36) in the same direction in which the drive link assembly (36) was removed. If the drive link assembly (36) is new, you can install it in either direction.
  4. Install the drive link assembly (36) to the drive and driven sprockets (37 and 91).
  5. Install as a complete assembly, the drive sprocket (37) the driven sprocket (91), and the drive link assembly (36) onto the transmission.
scientia non olet · About LEMON Manuals