LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 754 (Automatic Transaxle - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Channel Plate Assembly Assemble >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Accumulator Piston Seals
    GM55115Courtesy of GENERAL MOTORS CORP.
  1. Assemble the new accumulator piston seals (30) on the three accumulator pistons (29).
  2. Install the 1-2 and 2-3 accumulator assist springs (47, 125).
  3. Install the accumulator pistons (29) into the channel plate over the guide pins. The pistons are identical. You can assemble the pistons in any of the three accumulator bores.
  4. In order to retain the pistons, apply J 36850  onto the piston seals. See Special Tools .
  5. Install the manual valve (800) into channel plate.
scientia non olet · About LEMON Manuals