LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions - On Vehicle >> Front Wheel Drive Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Remove the wheel driveshaft. Refer to Wheel Drive Shaft Replacement .
    4. Fig 1: Removing Axle Seal
    GM863208Courtesy of GENERAL MOTORS CORP.
  4. Use the J 23907  in order to remove the seal.
  5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.
scientia non olet · About LEMON Manuals