Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When removing or installing the backup lamp switch, do not use an open end wrench. Use only a socket in order to avoid damage to the switch assembly.

Remove the left front wheel. Refer to Tire and Wheel Removal and Installation .
Disconnect the backup lamp connector (1).

Fig 1: Locating Backup Light Connector & VSS Connector

Courtesy of GENERAL MOTORS CORP.

Remove the backup lamp switch assembly.