LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 747 (Wiper System & Washer System) >> Repair Instructions >> Windshield Wiper Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Motor
    GM1235608Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor to the wiper transmission assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Install the wiper motor screws.

    Tighten:  Tighten the screws to 8 N.m (71 lb in).

    3. IMPORTANT: The new wiper motor comes pre-timed from the factory in the PARK position. Do Not energize the wiper motor prior to installation.
    If the wiper motor is energized, the wiper motor must be electrically returned to the PARK position as shown, prior to installation.
  3. Install the wiper motor crank arm and crank arm nut.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

  4. Install the windshield wiper transmission. Refer to Windshield Wiper Transmission Replacement .
  5. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
scientia non olet · About LEMON Manuals