LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 747 (Wiper System & Washer System) >> Repair Instructions >> Windshield Washer Pump Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
    3. Fig 1: View Of Washer Hose & Washer Pump
    GM1655548Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the washer hose (1) from the washer container hose (3) at the fender flange.
    4. Fig 2: Identifying Washer Hose & Fender Flange Clip
    GM1655549Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the washer hose (1) from the air inlet grille panel plenum.
  5. Disconnect the washer hose from the windshield washer nozzles.
  6. Disconnect the fender flange clip (3) from the fender flange.
  7. Pull the washer hose pump end out alongside the right front inner fender and into the engine compartment.
  8. Remove the washer hose from the vehicle.
scientia non olet · About LEMON Manuals