LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 747 (Wiper System & Washer System) >> Repair Instructions >> Windshield Washer Pump Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Washer Hose & Fender Flange Clip
    GM1655549Courtesy of GENERAL MOTORS CORP.
  1. Position the washer hose to the vehicle.
  2. Secure the washer hose (1) to the air inlet grille panel at four locations.
  3. Secure the washer hose to the windshield washer nozzles.
  4. Route the washer hose down alongside the right front inner fender flange.
  5. Connect the washer hose fender flange clips (3) to the fender flange.
    6. Fig 2: View Of Washer Hose & Washer Pump
    GM1655548Courtesy of GENERAL MOTORS CORP.
  6. Connect the washer hose (1) to the washer pump hose (3) and secure the fender flange clip (2).
  7. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  8. Close the hood.
scientia non olet · About LEMON Manuals