LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 745 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Underhood Electrical Center or Junction Block Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Underhood Electrical Center
    GM1548078Courtesy of GENERAL MOTORS CORP.
  1. Position the underhood electrical center (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten all of the underhood electrical center bolts (3).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Connect the positive battery cables (5) to the underhood electrical center.
  4. Install the underhood positive battery terminal lug (4).

    Tighten:  Tighten the terminal lug to 15 N.m (133 lb in).

  5. Install the cover (2) to the underhood electrical center.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals