LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 739 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement - On Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Outer Tie Rod
    GM854987Courtesy of GENERAL MOTORS CORP.
  1. Remove the rack and pinion outer tie rod end. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  2. Remove the rack and pinion inner tie rod nut and discard it.
  3. Remove the outer steering gear boot clamp.
  4. Cut the inner steering gear boot clamp and discard it.
    5. Fig 2: View Of Steering Gear Boot & Clamp
    GM854991Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: After removing the boot, inspect the inner tie rod for evidence of corrosion or contamination. If none is evident, continue with the repair. If corrosion or contamination is evident, replace the steering gear.
  5. Remove the steering gear boot from the steering gear.
scientia non olet · About LEMON Manuals