Stabilizer Shaft Insulator Replacement (FE5)
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications .Preliminary Procedure: Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
. |
|
| 1 | Front Stabilizer Shaft Clamp Bolt Tighten: 50 N.m (37 lb ft) |
| 2 | Front Stabilizer Shaft Clamp Nut Tighten: 50 N.m (37 lb ft) |
| 3 | Front Stabilizer Shaft Clamp |
| 4 | Front Stabilizer Shaft Insulator Tip: Place the cut line of the insulator facing the rear of the vehicle. |