LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 737 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Crankshaft Rear Oil Seal
    GM412495Courtesy of GENERAL MOTORS CORP.
  1. Use the J 42067  and install the seal.
    2. Fig 2: View Of Flywheel
    GM412119Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the flywheel.

    Tighten:  Tighten the flywheel bolts to 53 N.m (39 lb ft) plus 25 degrees.

  3. Install the transmission. Refer to Transmission Replacement for the M86/N94 Getrag transmission or Transmission Replacement for the 4T40-E/4T45-E transmission.
scientia non olet · About LEMON Manuals