Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Negative Battery Cable

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable (1) to the conduit.

Fig 2: Cutting Open Tape On Positive/Negative Battery Cable Conduit

Courtesy of GENERAL MOTORS CORP.

Wrap tape around the positive/negative battery cable conduit (1).

Fig 3: Installing Positive Battery Cable Terminal To Starter Solenoid (RPO LSJ)

Courtesy of GENERAL MOTORS CORP.

If equipped with RPO LSJ, perform the following steps, install the positive battery cable terminal (2) to the starter solenoid.

NOTE: Refer to Fastener Notice .

Install the starter solenoid terminal nut (3).
Tighten: Tighten the nut to 17 N.m (13 lb ft).

Fig 4: Installing Positive Battery Cable Terminal To Starter Solenoid (RPOs L61 or LE5)

Courtesy of GENERAL MOTORS CORP.

If equipped with RPOs L61 or LE5, perform the following steps, Install the positive battery cable terminal (3) to the starter solenoid.
Install the starter solenoid terminal nut (4).
Tighten: Tighten the nut to 17 N.m (13 lb ft).
Lower the vehicle.

Fig 5: View Of Junction Block Cover

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable terminal (2) to the junction block stud.
Install the junction block nut (1).
Tighten: Tighten the nut to 17 N.m (13 lb ft).
Install the positive battery cable clip (3) to the ECM bracket.
Install the junction block cover.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .