LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 736 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnection and Connection >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Battery Connections
GM1656237Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Clean any existing oxidation from the contact face of the battery terminal and battery cable using a wire brush before installing the battery cable to the battery terminal.
  1. Position the negative battery cable (3) to the battery.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the negative battery cable bolt (2).

    Tighten:  Tighten the bolt to 17 N.m (13 lb ft).

  3. Install the rear compartment floor mat.
  4. Reset the radio stations and the clock.
scientia non olet · About LEMON Manuals