LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 730 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Throttle Body & Bolts
    GM1769706Courtesy of GENERAL MOTORS CORP.
  1. Inspect the throttle body seal, and replace if necessary.
  2. Position the throttle body to the intake manifold.
    NOTE: Refer to Fastener Notice .
  3. Install the throttle body bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 2: Identifying Brake Booster Auxiliary Pump Connector
    GM1826929Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1) to the brake booster auxiliary pump.
  5. Install the brake booster auxiliary pump electrical connector clip to the bracket.
    6. Fig 3: Identifying ETC Connector
    GM1825527Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine wiring harness electrical connector (1) to the ETC.
  7. Install the charge air cooler outlet pipe. Refer to Charge Air Cooler Outlet Pipe Replacement .
scientia non olet · About LEMON Manuals