Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lubricating Male Pipe End

Courtesy of GENERAL MOTORS CORP.

Apply a few drops of clean engine oil to the male connection end.

Fig 2: View Of Quick-Connect Fitting

Courtesy of GENERAL MOTORS CORP.

Push both sides of the quick connect fitting together in order to cause the retaining feature to snap into place.

Fig 3: Ensuring Secure Connection

Courtesy of GENERAL MOTORS CORP.

Once installed, pull on both sides of the quick connect fitting in order to make sure the connection is secure.