LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 730 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying MAP Sensor Connector
    GM1825525Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector (2) from the manifold absolute pressure (MAP) sensor.
    2. Fig 2: Identifying MAP Sensor & Bolts
    GM1828338Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor bolts.
  3. Remove the MAP sensor and O-ring seal from the intake manifold.
scientia non olet · About LEMON Manuals