LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 730 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Filler Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Gasoline/Gasoline Vapors Caution .
    Fig 1: Identifying Fuel Fill Pipe To Fill Pipe Housing Bolts
    GM1637027Courtesy of GENERAL MOTORS CORP.
  1. Drain the fuel tank. Refer to Fuel Tank Draining .
  2. Remove the fuel fill pipe to fill pipe housing bolts.
  3. Remove the fuel fill pocket. Refer to Fuel Tank Filler Pipe Housing Replacement .
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    5. Fig 2: Identifying Fuel Fill Pipe Lower Bolt
    GM1636691Courtesy of GENERAL MOTORS CORP.
  5. Remove the fuel fill pipe lower bolt.
    6. Fig 3: Identifying Fuel Fill Pipe Hose
    GM1636704Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the fuel tank vent pipe quick connect fittings (1, 3). Refer to Plastic Collar Quick Connect Fitting Service .
  7. Loosen the fuel fill pipe hose clamp (2) at the fuel tank.
  8. Remove the fuel fill pipe hose from the fuel tank.
    9. Fig 4: Identifying Fuel Fill Pipe
    GM1636690Courtesy of GENERAL MOTORS CORP.
  9. Remove the fuel fill pipe from the vehicle.
scientia non olet · About LEMON Manuals