LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 730 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Chassis/Canister >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Line & Retainers
    GM2034701Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP line into the plastic retainers (3).
  2. Connect the EVAP line to the plastic retainers (2).
  3. Connect the quick connect fitting (1). Refer to Plastic Collar Quick Connect Fitting Service .
    4. Fig 2: View Of Evaporative Emission Hoses/Pipes - Chassis/Canister
    GM2034674Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP line to the plastic retainers (2).
    5. NOTE: Refer to Fastener Notice .
  5. Install the retaining nuts (1).

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  6. Remove the caps or plugs from the purge pipe and the engine purge hose.
  7. Connect the purge pipe to the engine purge hose. Refer to Evaporative Emission Hoses/Pipes Replacement - Engine/Chassis .
scientia non olet · About LEMON Manuals