LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 730 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Charge Air Cooler Inlet Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Charge Air Cooler Inlet Pipe Clamp
    GM2016295Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Remove any oil film from inside the pipes.
  1. Install the charge air cooler pipe (2) and tighten the charge air cooler inlet pipe clamp.
    2. Fig 2: View Of Charge Air Cooler Inlet Pipe
    GM2001806Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the charge air cooler inlet pipe (2) to the charge air cooler (3).

    Tighten:  Tighten the clamp to 5 N.m (44 lb in).

  3. Install the front bumper fascia air deflector. Refer to Front Bumper Fascia Air Deflector Replacement .
scientia non olet · About LEMON Manuals