Circuit/System Verification
WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, observe the scan tool Driver Door Ajar Sw parameter while opening and closing the driver door. The parameter should change between Door Closed and Door Ajar.
- If the parameter does not change, refer to Driver Door Ajar Malfunction in Circuit/System Testing .
- With the passenger doors closed, observe the scan tool Door Ajar Switch parameter while opening and closing each door. The parameter should change between Door Closed and Door Ajar.
- If the parameter does not change, refer to Passenger Door Ajar Malfunction in Circuit/System Testing .