LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 727 (Steering Wheel & Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Failure to transfer the scribed marks may result in an off-center steering wheel.
  1. If installing a new intermediate steering shaft then transfer the scribed marks made previously.
  2. Position the intermediate steering shaft and seal assembly to the vehicle.
    3. IMPORTANT: Inspect the intermediate steering shaft seal from the engine compartment to make sure it is seated properly.
  3. Seat the intermediate steering shaft seal to the body pass-through.
  4. Align the scribed marks on the intermediate steering shaft to the scribed marks on the steering column shaft.
    5. Fig 1: View Of Upper Intermediate Shaft Pinch Bolt And Column
    GM854769Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Connect the intermediate steering shaft to the steering column shaft.
  6. Install a new intermediate steering shaft bolt.

    Tighten:  Tighten the bolt to 34 N.m (25 lb ft).

    7. Fig 2: View Of Intermediate Shaft-To-Steering Gear Pinch Bolt
    GM851655Courtesy of GENERAL MOTORS CORP.
  7. Connect the intermediate steering shaft to the steering gear.
  8. Install a new intermediate steering shaft bolt.

    Tighten:  Tighten the bolt to 34 N.m (25 lb ft).

  9. Install the left front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals