Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sizing Tool

Courtesy of GENERAL MOTORS CORP.

Insert the J 44551-6 Sizing Tool (1) into the suction hose to select the correct size suction screen.
Insert the suction screen into the compressor end of the suction hose.

Fig 2: Identifying Mandrel And Suction Screen Installer

Courtesy of GENERAL MOTORS CORP.

Install the correct mandrel (1) to the J 44551-5 Screen Installation Tool.

Fig 3: Identifying Proper Placement Of J 44551-5

Courtesy of GENERAL MOTORS CORP.

Install the J 44551-5 (3) over the end of the suction hose and the suction screen (2).

IMPORTANT: Correct placement of the J 44551-5 is critical.

Tighten the forcing screw of the J 44551-5.
The suction screen is fully installed when the screen is flush with the end of the suction hose fitting.
Remove the J 44551-5 from the suction hose.
Install the J 44551-1 Suction Screen Notification Label.