LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Compressor Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice .
    Fig 1: View Of Compressor Pressure Relief Valve
    GM872550Courtesy of GENERAL MOTORS CORP.
  1. Install the pressure relief valve and seal to the compressor.

    Tighten:  Tighten the compressor pressure relief valve to 7 N.m (62 lb in).

  2. Lower the vehicle.
  3. Evacuate and charge the refrigerant system. Refer to Refrigerant Recovery and Recharging (Non HP2) .
  4. Leak test the fittings using the J 39400-A  . See Special Tools .
scientia non olet · About LEMON Manuals