LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Evaporator Hose Assembly Replacement (L61, LE5 - 1st Design) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Evaporator Tube & Compressor Suction Hose At TXV
    GM872539Courtesy of GENERAL MOTORS CORP.
  1. Install new sealing washers on the condenser tube and evaporator hose fittings. Refer to Sealing Washer Replacement .
  2. Install the condenser tube and evaporator hose to the TXV.
    3. NOTE: Refer to Fastener Notice .
  3. Install the TXV nut.

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

    4. Fig 2: View Of Compressor & Evaporator Hoses (2.2L)
    GM872544Courtesy of GENERAL MOTORS CORP.
  4. Install new seal washer to the compressor hose. Refer to Sealing Washer Replacement .
  5. Install the compressor hose and nut to the evaporator hose.

    Tighten:  Tighten the nut to 20 N.m (15 lb ft).

  6. Evacuate and charge the refrigerant system. Refer to Refrigerant Recovery and Recharging (Non HP2) .
  7. Leak test the fittings using the J 39400-A  . See Special Tools .
scientia non olet · About LEMON Manuals