LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of A/C Refrigerant Pressure Sensor
    GM872549Courtesy of GENERAL MOTORS CORP.
  1. Install a new seal in the pressure sensor.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the pressure sensor to the compressor hose.

    Tighten:  Tighten the pressure sensor to 5 N.m (44 lb in).

    3. Fig 2: View Of Pressure Transducer Electrical Connector
    GM872571Courtesy of GENERAL MOTORS CORP.
  3. Connect the pressure sensor electrical connector.
  4. Lower the vehicle.
  5. Leak test the fittings using the J 39400-A  . See Special Tools .
scientia non olet · About LEMON Manuals