LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 2.4L (LE5)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Powertrain Mount Balance - Total Mounts

Powertrain Mount Balance - Total Mounts

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.
    Fig 1: Identifying Front Transaxle Mount Through Bolt
    GM1647337Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Loosen the front transaxle mount through bolt.
    3. Fig 2: Identifying Rear Transaxle Mount Through Bolt
    GM1647340Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear transaxle mount through bolt.
  4. Lower the vehicle.
  5. Position two floor jacks with wood blocks under the engine and transaxle in order to support the powertrain assembly.
    6. Fig 3: Identifying Transaxle Mount to Transaxle Bolts
    GM1647344Courtesy of GENERAL MOTORS CORP.
  6. Loosen the transaxle mount to transaxle bolts.
    7. Fig 4: View Of Engine Mount To Bracket Bolts
    GM1656093Courtesy of GENERAL MOTORS CORP.
  7. Loosen the engine mount to bracket bolts.
  8. Reposition both floor jacks in order to allow a 1/8 inch gap between the mount and bracket.
    9. Fig 5: Identifying Transaxle Mount to Transaxle Bolts
    GM1647344Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  9. Tighten the transaxle mount to transaxle bolts in the sequence shown.

    Tighten:  Tighten the bolts to 45 N.m (33 lb ft).

    10. Fig 6: View Of Engine Mount To Bracket Bolts
    GM1656093Courtesy of GENERAL MOTORS CORP.
  10. Tighten the engine mount to bracket bolts in the sequence shown.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  11. Remove the floor jacks from under the oil pan.
  12. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
  13. Raise the vehicle.
    14. Fig 7: Identifying Rear Transaxle Mount Through Bolt
    GM1647340Courtesy of GENERAL MOTORS CORP.
  14. Tighten the rear transaxle mount through bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft).

    15. Fig 8: Identifying Front Transaxle Mount Through Bolt
    GM1647337Courtesy of GENERAL MOTORS CORP.
  15. Tighten the front transaxle mount through bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft).

  16. Lower the vehicle.
scientia non olet · About LEMON Manuals