LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 2.4L (LE5)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Powertrain Mount Balance - Lower Mount

Powertrain Mount Balance - Lower Mount

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.
    Fig 1: Identifying Front Transaxle Mount Through Bolt
    GM1647337Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Loosen the front transaxle mount through bolt.
    3. Fig 2: Identifying Rear Transaxle Mount Through Bolt
    GM1647340Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear transaxle mount through bolt.
  4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
    5. NOTE: Refer to Fastener Notice .
  5. Tighten the rear transaxle mount through bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft).

    6. Fig 3: Identifying Front Transaxle Mount Through Bolt
    GM1647337Courtesy of GENERAL MOTORS CORP.
  6. Tighten the front transaxle mount through bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft).

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals