LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 2.4L (LE5)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Flywheel (Automatic Transaxle)
    GM1625312Courtesy of GENERAL MOTORS CORP.
  1. Install the manual transaxle flywheel, if equipped.
    2. NOTE: Refer to Fastener Notice .
  2. Install the NEW manual transaxle flywheel bolts, if equipped.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059  .

    3. Fig 2: View Of Flywheel (Manual Transaxle)
    GM1578311Courtesy of GENERAL MOTORS CORP.
  3. Install the automatic transaxle flywheel, if equipped.
  4. Install the NEW automatic transaxle flywheel bolts, if equipped.

    Tighten:  Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059  .

  5. Remove the J 38122-A  .
  6. If equipped with a manual transaxle, install the clutch. Refer to Clutch Drive Plate and Clutch Driven Plate (M86) or Clutch Drive Plate and Clutch Driven Plate (MU3) .
  7. If equipped with a automatic transaxle, install the transaxle. Refer to Transmission Replacement .
scientia non olet · About LEMON Manuals