LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 2.4L (LE5)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Tensioner
    GM1571145Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt tensioner.
    2. NOTE: Refer to Fastener Notice .
  2. Install the drive belt tensioner bolt.

    Tighten:  Tighten the bolt to 45 N.m (33 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals