LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 2.4L (LE5)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Camshaft Position Actuator Solenoid Valve Electrical Connectors
    GM1647538Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  3. Disconnect the intake (3) and exhaust (2) camshaft position actuator solenoid valve electrical connectors.
    4. Fig 2: View Of Engine Harness Clips To Camshaft Cover
    GM1656114Courtesy of GENERAL MOTORS CORP.
  4. Remove the ignition coils. Refer to Ignition Coil Replacement .
  5. Remove the engine harness clips (1, 2) from the cover.
    6. Fig 3: View Of Caps Or Plugs, Fuel Line And Fuel Rail
    GM1647977Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel feed line retainers (1, 2) from the engine brackets.
    7. Fig 4: Identifying Camshaft Cover & Bolts
    GM1578306Courtesy of GENERAL MOTORS CORP.
  7. Remove the camshaft cover bolts.
  8. Remove the camshaft cover.
scientia non olet · About LEMON Manuals