Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Camshaft Cover & Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the camshaft cover and bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 2: View Of Engine Harness Clips

Courtesy of GENERAL MOTORS CORP.

Install the ignition coils. Refer to Ignition Coil Replacement .
Install the engine harness clips (1, 2) to the cover.

Fig 3: View Of Caps Or Plugs, Fuel Line And Fuel Rail

Courtesy of GENERAL MOTORS CORP.

Install the feed line retainers (1, 2) to the engine brackets.

Fig 4: Identifying Camshaft Position Actuator Solenoid Valve Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the intake (2) and exhaust (2) camshaft position actuator solenoid valve electrical connectors.
Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .