LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Engine Exhaust System) >> Repair Instructions >> Exhaust Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Heat Shield
    GM1650894Courtesy of GENERAL MOTORS CORP.
  1. Position the exhaust heat shield to the underbody.
    2. NOTE: Refer to Fastener Notice .
  2. Install the heat shield nut.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  3. Install NEW heat shield rivets.
  4. Remove the support from the muffler pipe.
  5. Install the muffler pipe forward insulators to the underbody hangers.
  6. Install the catalytic converter. Refer to Catalytic Converter Replacement (RPO L61)  or Catalytic Converter Replacement (RPO LE5)  or Catalytic Converter Replacement (RPO LSJ) .
scientia non olet · About LEMON Manuals