Clutch Housing Assemble

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

83 90 114 Sleeve. See Special Tools .
83 90 312 Drift, Bearing Race Input Shaft. See Special Tools .
87 91 311 Sleeve, Bearing Driver Shaft. See Special Tools .
87 92 210 Support, Differential Bearing. See Special Tools .
87 92 236 Support. See Special Tools .
J 44809 Output Shaft Seal Installer. See Special Tools .

Fig 1: Installing Differential Bearing Race

Courtesy of GENERAL MOTORS CORP.

Press in the new differential bearing race using the J 44809 . See Special Tools . Use the 87 92 236 as a base for the pressing operation. See Special Tools .

Fig 2: Installing Output Shaft Seal

Courtesy of GENERAL MOTORS CORP.

Install the new axle using the J 44809 . See Special Tools .

Fig 3: Installing Input Shaft Bearing Race

Courtesy of GENERAL MOTORS CORP.

Press in the new input shaft bearing race using the 83 90 312 (1). See Special Tools . Use the 83 90 114 (2) and the 87 91 311 (3) as a base for the pressing operation. See Special Tools .