LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 699 (Manual Transaxle - Mu3) >> Repair Instructions >> Axle Seals Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Axle Seal
    GM895455Courtesy of GENERAL MOTORS CORP.
  1. Use the SA9133T  to install a new seal. See Special Tools . Ensure that the seal is seated flush to the outer bore area.
  2. Install the wheel driveshaft or intermediate drive shaft. Refer to Wheel Drive Shaft Replacement or Intermediate Drive Shaft Replacement .
  3. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals