LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 698 (Manual Transmission - GETRAG (M86)) >> Repair Instructions >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate a new O-ring with DEXRON III transmission fluid.
  2. Install the new O-ring.
  3. Fig 1: Identifying VSS Retainer
    GM12407Courtesy of GENERAL MOTORS CORP.
  4. Install the VSS assembly.
  5. Install the VSS retainer.
  6. NOTE: Refer to FASTENER NOTICE .
    Fig 2: View Of VSS Retainer Bolt
    GM623141Courtesy of GENERAL MOTORS CORP.
  7. Install the VSS retainer bolt.

    Tighten:  Tighten the bolt to 12 N.m (8 lb ft).

  8. Fig 3: Connecting VSS Connector To VSS
    GM12406Courtesy of GENERAL MOTORS CORP.
  9. Connect the VSS connector to the VSS.
  10. Lower the vehicle.