Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Floor Pan Grommet & Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Position the shifter on the studs and install the front 2 nuts (2).

NOTE: Refer to FASTENER NOTICE .

Install the 2 rear nuts (3).
Tighten: Tighten the nuts to 25 N.m (18 lb ft).
Install the shift cables. Refer to Shift Cable Replacement .
Install the console. Refer to Front Floor Console Replacement .