LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 698 (Manual Transmission - GETRAG (M86)) >> Repair Instructions >> Rear Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Sealant To Rear Cover
    GM514887Courtesy of GENERAL MOTORS CORP.
  1. Install sealant Saturn P/N 21019581 to the rear cover.
    2. Fig 2: View Of Rear Cover
    GM513914Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The oil guide only installs in one direction. Ensure the oil guide is completely seated in the gear shafts.
  2. Install the oil guide.
    3. NOTE: Refer to Fastener Notice .
  3. Install the rear cover.

    Tighten:  Tighten the rear cover bolts to 25 N.m (18 lb ft).

  4. Install the left front wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
scientia non olet · About LEMON Manuals