LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 698 (Manual Transmission - GETRAG (M86)) >> Repair Instructions >> Axle Shaft Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wheel Drive Shaft Into Transaxle Through J 44394
    GM857191Courtesy of GENERAL MOTORS CORP.
  1. Use the J 44385  and the J 7079-2  in order to install a new seal. See Special Tools . Ensure that the seal is seated flush to the outer bore area.
  2. Lubricate the seal with Dexron®-III transmission fluid Saturn P/N 21019223.
  3. Install the wheel driveshaft. Refer to Wheel Drive Shaft Replacement .
  4. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals