LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 697 (Engine Cooling System) >> Repair Instructions >> Thermostat Replacement (RPO L61) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Thermostat Housing Cover Bolts & Cover
    GM1713064Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW thermostat cover O-ring seal into the recess groove.
  2. Install the thermostat.
    3. NOTE: Refer to Fastener Notice .
  3. Install the thermostat cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 2: Identifying Radiator Outlet Hose
    GM1649362Courtesy of GENERAL MOTORS CORP.
  4. Install the radiator outlet hose to the thermostat housing.
  5. Position the radiator outlet hose clamp (1) at the thermostat housing.
  6. Fill the cooling system. Refer to Draining and Filling Cooling System (2.0L (LSJ))  or Draining and Filling Cooling System (2.2L (L61), 2.4L (LE5))  or Draining and Filling Cooling System (GE 47716 Fill) .
  7. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals