Circuit Description

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

The camshaft position (CMP) sensor provides the powertrain control module (PCM) with a signal representing the camshaft's rotational position. The CMP sensor is a hall effect switch that works in conjunction with a 4X reluctor wheel. The reluctor wheel consists of 4 pairs of rising and falling edges that are differently spaced. The CMP sensor produces a magnetic field. When the camshaft rotates, and the reluctor wheel edge passes by the CMP sensor, there is a change in the magnetic field. The PCM views each transition from low to high as one signal. The PCM receives 4 signals per camshaft revolution. The CMP sensor has the following circuits:

A 5-volt circuit
A low reference circuit
A signal circuit

The PCM supplies 5 volts to the CMP sensor on the 5-volt reference circuit, and provides a low reference circuit. The CMP sensor provides a 4X signal to the PCM on the signal circuit. If the PCM detects extra or missing CMP sensor signal transitions within a certain number of crankshaft revolutions, DTC P0340 will set.