Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DTC P2535
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Power Distribution Schematics Connector End View Reference: Master Electrical Component List |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to DIAGNOSTIC STARTING POINT - VEHICLE |
| 2 |
|
- | Go to Step 4 | Go to Step 3 |
| 3 | Connect a test lamp between the Run/Crank voltage circuit on the body control module (BCM) side of the relay and a good ground. Does the test lamp illuminate? |
- | Go to Step 5 | Go to Step 8 |
| 4 | Test the Run/Crank voltage circuit between the PCM and the Run/Crank relay for a short to voltage. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 6 |
| 5 | Test the Run/Crank voltage circuit between the BCM and the Run/Crank relay for a short to voltage. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 7 |
| 6 | Test for an intermittent and for a poor connection at the PCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 9 |
| 7 | Test for an intermittent and for a poor connection at the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 10 |
| 8 | Replace the Run/Crank relay. Refer to Relay Replacement (Attached to Wire Harness)
or Relay Replacement (Within an Electrical Center)
. Did you complete the replacement? |
- | Go to Step 11 | - |
| 9 | Replace the PCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 11 | - |
| 10 | Replace the BCM. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 11 | - |
| 11 |
|
- | Go to Step 2 | Go to Step 12 |
| 12 | With a scan tool, observe the stored information, Capture Info. Does the scan tool display any DTCs that you have not diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |