LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Fluid Pressure Manual Valve Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating TFP Switch Assembly
    GM1205810Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission side cover. Refer to Case Side Cover Replacement .
  2. Remove the six bolts from the transmission fluid pressure (TFP) switch assembly.
  3. Remove the TFP switch assembly from the control valve body assembly. The 4 pressure switch O-rings are reusable and should remain with the TFP switch assembly.
scientia non olet · About LEMON Manuals